Inventory

Automated Finishing,No.2H-36, 2-Spdl, Rotating Tub,Slurry Deburring Machine 1991   Our stock number: 23713

Automated Finishing,No.2H-36, 2-Spdl, Rotating Tub,Slurry Deburring Machine 1991

Click on picture below for larger version
Automated Finishing,No.2H-36, 2-Spdl, Rotating Tub,Slurry Deburring Machine 1991Automated Finishing,No.2H-36, 2-Spdl, Rotating Tub,Slurry Deburring Machine 1991Automated Finishing,No.2H-36, 2-Spdl, Rotating Tub,Slurry Deburring Machine 1991Automated Finishing,No.2H-36, 2-Spdl, Rotating Tub,Slurry Deburring Machine 1991
Automated Finishing,No.2H-36, 2-Spdl, Rotating Tub,Slurry Deburring Machine 1991Automated Finishing,No.2H-36, 2-Spdl, Rotating Tub,Slurry Deburring Machine 1991Automated Finishing,No.2H-36, 2-Spdl, Rotating Tub,Slurry Deburring Machine 1991

Serial No. 2322  
New - 1991

SPECIFICATIONS:
Floor Area Requirements..............6'6" L x 4'6" W x 5' H
Work Tray.............................................40" H

GENERAL INFORMATION:
The Model 2H-36 Spindle Type Finishing Machine is composed of the following
major components: (1) The Rotating Tube that carries the finishing media; (2)
The Two Spindle Supporting Heads; (3) The Two Spindle Assemblies; (4) The
Structural Base; and (5) The Electrical Controls.

The rotating tub measures 36" wide in diameter by 18-1/2" in depth and is
fabricated of 3/16" steel plate of all welded construction with the tub bottom
further reinfored with structural channels. A 3" wide section of the tub at
the bottom periphery is perforated and covered on the O.D. with fine mesh
screen to allow continual drainage of liquids from the tubs interior.

The tub is mounted on the vertical output shaft of a heavy duty gear reducer
driven by a 15 HP variable speed drive unit for 460 volt, 3 phase, 60 cycle
operation with a tub speed of up to 1200 SFM (Surface Feet Per Minute).

The spindle support heads are fabricated of heavy section structural steel
members and are rigidly gusseted to provide an integral rigid unit capable of
maintaining positive alignment of the spindle with respect to the rotating
tub.  Raising and lowering of spindles is accomplished with an air cylinder. 
Spindles are adjustable through a 20 degree range fore and aft of the flow of
material in the rotating tub and from 0 degrees to 20 degrees from
perpendicular to the outer periphery of the tub together with 3-1/2"
horizontal extension.

EQUIPPED WITH:
Texas Instruments Series 305-O5B Programmable Controller
ATC Spindle Counters (2) Each Forward & Reverse
Control for Variable Tub Speed with Digital Tachometer

*Preliminary Specifications Subject to Verification.



Get a Quote

Company:
Contact:
Email:
Tel:
Address:
City St ZIP:
Fax:

How did you hear of us?
Additional information on your request:
   

Please enter text from above:

RETURN to complete inventory display       RETURN to our home page