|
Serial No. 797510 New - 1994
OVERVIEW T-200:
The T-Drill method of pipe branching is applicable to almost all malleable
materials including Stainless Steel, Cu Ni, Aluminum Alloys & Copper. It is
an automatic branching machine that produces consistent, high quality outlets.
PROCESS:
1. The run pipe is manually clamped into the carriage assembly and moved
underneath the milling/collaring head. The operator acknowledges the control
settings and initiates the start cycle.
2. An elliptical pilot hole is cut in the pipe. Both diagonals of the
elliptical hole can be adjusted separately up to a max. pilot hole size of
8.27" x 6.1".
3. The T-200 System then calls upon the forming pins of the collaring
head which are extended and the collar is formed.
4. The collar is trimmed in a mill facing operation to the desired height.
5. The pipe is repositioned or replaced and the cycle can begin again.
SPECIFICATIONS:
Collaring Range / Maximum Tee Size 3/4" - 8" IPS**
Run Tube (Pulling Tee Out) 1" - 16" IPS**
Wall Thickness - Maximum SCH. 10 - Stainless
Class 200 - CuNi
Type K - Copper
Electrics 2420V / 3 Phase / 60HZ
Air Supply 90 PSI ( 6 Bar)
Dimensions 100"L x 80"W x 90"H
Approximate Weight 7950 Lbs.
**For capacities, wall thickness & tube dimensions, go to: www.t-drill.com
EQUIPPED WITH:
Texas Microsystems Model 1448 Control
EQUIPPED WITH THE FOLLOWING TOOLING:
Collaring Heads with Formation Pins
Part #5120201 75 - 90mm Diameter
Part #5120120 42 - 54mm Diameter
Pipe Clamps
(2) 101.6mm (On Machine)
(2) 114.3mm
Additional Tooling
(1) Locking Lever
*Preliminary Specifications Subject to Verification.